Form-It Anchor 14ga Steel (3, 10, 100, 500 pc)

A concrete form anchor is a fall protection tie-off point installed into formwork before a concrete deck pour. The anchor embeds in the cured concrete during the pour and provides personal fall arrest during finishing operations and subsequent work on the deck. The Super Anchor Form-It is the contractor standard for poured-in-place commercial concrete work in Canada.

Determined by deck area, crew size, and the project’s fall protection plan. Typical spacing on commercial decks is one anchor per worker per work zone, with adequate spacing for fall arrest geometry. For large pours, work with your fall protection specifier to lay out anchor positions before formwork goes in.

No. Form-It is a single-pour embedded anchor — once the concrete cures around it, the anchor is permanent (or removed/cut flush after the project if not retained as a permanent tie-off). For reusable concrete deck anchors on cured concrete, specify the Concrete Super Bolt (1040) or Sub-Surface Anchor (SSA) lines.

Form-It: pour-in-place embedded anchor for new concrete construction during the pour. Concrete Super Bolt: surface-mounted anchor for installation on cured concrete (retrofit, post-construction tie-off). Choose Form-It for new pours; Concrete Super Bolt for existing decks.

Match pack size to operation scale: Pallet (1019-P, 2,500pc) for major commercial concrete operations specifying dozens of anchors per pour; Bulk Box (1019-B, 100pc) for mid-size commercial; Retail (1019, 10pc or 1019-3, 3pc) for small commercial and residential concrete work. Lower per-unit cost at larger pack sizes.

Variant-specific. The Form-It meets ANSI Z359 fall protection standards; CSA Z259 certification varies by SKU. Verify the certification stamp on the anchor and on the product page. Most provincial OHS codes accept ANSI Z359 anchors on construction sites when CSA equivalents are not available.